-
The crossarm clamp is part of a ramp's support assembly and is responsible for holding the crossarm in place on the leg. Crossarm clamps are sold individually and include all necessary hardware.
-
ANSI loops are the rounded ends of Rampit USA handrails. ANSI loops include pre-installed aluminum inserts (not pictured) and can be flipped to angle upwards or downwards.
-
All Rampit USA aluminum ramps and platforms are assembled using a series of inter-connected pieces of light, and/or heavy tread. All tread pieces are six inches in length and can be cut to any width necessary. Medium tread is used in all ramps and commercial platforms. There are two different types of medium tread in all Rampit USA ramp sections. The first piece of tread is open on the front and the back, and is known as starter tread. This enables ramp sections to be connected to one another. All remaining tread on a ramp section is standard medium tread, and is open on the front, but closed on the back.
-
Stringers are shaped like an upside-down letter "F" and enclose all Rampit USA ramps and platforms. On platforms, two of the four stringers are usually flipped upside-down to create a smooth transition on and off the platform. Platform stringers are cut at 45-degree angles, whereas ramp stringers are cut at 90-degree angles. Stringers are sold individually and cut to the length specified. For a matching set, please add two of the same size to your cart.
-
Ramp handrails are sold as a set and only include hardware for installation. Square ends, ANSI Loops, Knuckles, Corners, Caps, and inserts needed for terminating or changing handrail direction are all sold separately.
-
Platform handrails are priced and sold individually and do not include ninety-degree corners or plastic knuckles for connecting multiple handrails.
-
The built-in adapter is an optional replacement for the uppermost piece of tread in a ramp section. The built-in adapter extends out beyond the end of the ramp, enabling the ramp to rest on the raised surface. Please select the length built-in adapter that best corresponds to the width of your ramp.
-
Square ends are used to enclose and terminate the end of a handrail when space may be an issue. Square ends are sold individually and include pre-installed aluminum inserts (not pictured). Rampit USA recommends using ANSI loops whenever space allows.